Electric Student Desk Assembly Requirements And Process

Electric Student Desk is a kind of desk and chair that can be manually adjusted in height. It can be adjusted according to the height of students when in use, so as to ensure that students can use it normally, ensure the healthy growth and development of body and mind, and ensure that students have A good learning environment is an important infrastructure for learning the state. Now many schools will choose to buy desks and chairs that can be raised and lowered for the healthy development of children. In this way, students' class status will be much better, it will not easily cause fatigue to students, and it will not cause students to suffer from myopia. , or hunchback and other various diseases. But many people don't know how to assemble and use the adjustable student desks and chairs after purchasing them. This will take a lot of time and effort, so how do assemble the adjustable student desks and chairs?

1. Install the foot pads first. When assembling, first install the foot pads on the four feet of the table. First, prepare the main accessories. First, find the three holes with your hands, and use 1cm screws to turn the installed overall bracket upside down on the table. On the board, you need to fix it everywhere with 3.5cm screws, and then tighten it with a screwdriver, but there are also some desks and chairs that do not need tools to install the feet, so it depends on the actual situation.

2. Connect the bracket, after installing the feet, distinguish left and right and up and down by the space above and the place where the feet are installed, and check which part each accessory belongs to. After completion, put the table board upside down on the ground, 1cm, to strengthen the table. There are more holes in the rear crossbar, and the rectangular frame is the left and right brackets respectively, starting to connect the bracket and the crossbar. The purpose is anti-wear and anti-slip. The two long rods are the front and rear cross rods, and the holes are fixed by hand first. The same needs are everywhere. The two support rods are respectively connected between the rear cross rod and the left and right brackets. The two short rods are Support rods, and screwdrivers to tighten them.

3. Assemble the table board. Align the table board with the crossbar and the hole on the table board from each corner. After the rear rod is connected, the white is upward. The three flat-head screws are 6cm long. After connecting the bracket and the crossbar. Connect the left and right brackets with the front and rear cross bars respectively, and then tighten them with a screwdriver.

4. Make adjustments. If there is no manual lifting during installation, then the height of the desks and chairs should be set during assembly, and then assembled, so that they will be more suitable for students when using them. If it is possible If you control the lifting by hand, you don't have to worry about this problem. In general, the use of adjustable student desks and chairs needs to be determined according to the specific usage of students.