Installation Steps For Electric Double Motor Lift Desk

Installation steps for Electric Double Motor Lift Desk :

1. First of all, the first step of the installation is to fix the beam because the holes reserved on the beam are in different positions, which can adapt to different desktops. For example, the tabletop is 120cm x 70cm, and the screws are 304 stainless steel, so there is definitely no problem with durability.

2. After the beam is fixed, it is time to install the electric lift desk legs. This lift desk is a rectangular three-section lift column, commonly referred to as a dual motor. It is also more convenient to install the table legs. Gently push the table legs into the beam, and then fix it with 4 stainless steel screws.

3. In terms of installation method, the legs of the table are divided into formal installation and inverted installation. The lifting area of ​​the formal installation is located at the table board, and the lifting area of ​​the inverted installation is located at the foot of the table. The lifting and lowering of the formal installation are smoother than that of the inverted installation. . Then what needs to be installed is the table feet. The table feet are generally perpendicular to the table feet, and the longitudinal dimension is longer, which can ensure the stability of the table feet. The legs of the table are basically flush with the table board, so there is no need to worry about tripping the elderly and children.

4. Four additional foot pads should be installed on the bottom of the table legs. On the one hand, it can prevent the stainless steel of the table feet from wearing the bottom surface, and the rubber feet can play a protective and anti-slip role. On the other hand, if the indoor floor is uneven, the foot pads can be adjusted to lower, which can also play a role in leveling.

5. After the foot pads are installed, the bench can be turned over, and the bench is basically formed. The beams of the work table are connected by a U-shaped structure, and the fixed plates are welded at the positions of the lifting columns at both ends of the work table to strengthen the structural strength. This structural design contributes greatly to the overall strength and stability of the bench.

6. The next step is to install the support frame (a very large bottom-side trapezoidal metal plate). The function of the support frame is to tilt the desktop vertically, because the desktop has to bear a lot of weight, so as to minimize the deformation of the desktop.

7. Since this electric lift desk adopts dual motors, it is equipped with an independent control box, which is connected to the left and right motors through two cables, and a power cord is also provided to connect the external power supply. Both the control box and the cables connecting the motors can be hidden inside the load-bearing beam, which not only looks neat but also has a stronger overall feel.

8. There is also a heart-warming detail design: wrap the power cord inside the anti-drop structure, so that you don't have to worry about dropping it. The lifting table is also ditched in the upper right corner of the interior for the wireless charger, which is fixed at the bottom of the table board through the bracket, and will not protrude from the bottom, reducing the thickness of the table board and the mobile phone, and realizing the adaptability of the wireless charging function.

9. The next step is to place the table board on the bracket and fix the screw to the embedded nut position of the tabletop, which is very convenient. Before installing the electric lift desk, you must first punctuate yourself, then use an electric drill to drive in the expansion screws, and finally install the screws, which is quite troublesome. For the user, the installation process is quite time-saving, labor-saving, and clean. The lifting controller also has a built-in nut, and the general controller is on the right side, which is just suitable for lifting most right hands. In addition to the digital display panel, there are three buttons on the bottom of the controller.