Detailed Steps Of Electric Standing Desk Installation

Detailed steps of Electric Standing Desk installation:

1. First use a ruler to measure the overall size of the table after installation (open the ruler to adjust to the radius of the table, place it in the center of the roller and turn it to a suitable position), then place the roller flat on a suitable installation position;

2. Put the steel frame flat on the roller so that the two are concentric, install the screws and fix it;

3. Then put the turntable (glass plate, marble plate or wooden board, etc.) flat on the steel frame, make the three concentric, install the screws, and fix it; Insert the plug of the induction cooker into the socket of the drum, and fix the plug board on the drum to the turntable with screws);

4. Connect the motor on the drum to the controller, and then turn on the power, check whether the turntable rotates normally, and cut off the power after normal;

5. Install the feet and the hoarding, level them, and fix the feet and the hoarding with screws (when the hoarding is almost installed, pay attention to installing the controller where there are holes in the hoarding and connect it to the motor on the drum);

6. Install the circular dining table, level the dining table with the dining table and fix it with screws, and then fix it with the feet;

7. Connect to the power supply and turn on the switch to use. (The switch is set by the user. It can be a wall switch or a remote control switch. It is recommended to be operated by the waiter. It starts to turn when the food is served and stops after the guests leave. Generally, the desk is equipped with a remote control switch).